Dynacord H 2500 Manuel d'utilisateur télécharger pdf (Page 18)

PowerH SERIES

18 Owner’s Manual

Output (Speakon-type Connectors / Terminals) in Bridged Mode

Setting the MODE switch on the power amp’s rear panel to BRIDGED lets the power amplifier run in

bridged mode operation and speaker connection has to be established using pins 1+ and 2+ of the

Speakon socket CH A, see illustration 2.16.

When using the speaker terminals in BRIDGED mode, the loudspeaker system has to be connected to the

red terminals of CHANNEL A and CHANNEL B. An illustration of how to correctly establish speaker

connection for this mode of operation is provided on the power amp’s enclosure.

Speakon CH A

Connection Pin 1+ 1- 2+ 2-

Channel Assignment A+ A- B+ B-

Table 2.6: Bi-Amp speaker connection in NORMAL operation mode, using only the Speakon A connector

Illustration 2.16: Speaker connection in BRIDGED operation mode, using Speakon A

Speakon CH A

Connection Pin 1+ 2+

Channel Assignment Bridged+ Bridged-

Table 2.7: Speaker connection in BRIDGED operation mode, using Speakon A

Illustration 2.17: Speaker connection in BRIDGED operation mode, using Terminals

CAUTION:

Due to the high current, using banana plugs for speaker connection is not permissible.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 147 148

Pas de commentaire

Dynacord H 2500 Manuel d'utilisateur Page 18